Once a year, let the salt run low and clean out the bottom of the brine tank to remove sediment.
Only fill the tank about 1/2 to 2/3 full. This prevents the bottom salt from turning into a mushy "sludge" that blocks the intake.
A hard crust of salt forms over the water, tricking the sensor or preventing water displacement. 40278 water softener full
If the backwash water cannot exit the house, it stays in the tank.
The most manual method but effective for small amounts. Wet/Dry Vac: The fastest way to suck out excess brine. Once a year, let the salt run low
If the tank is physically overflowing with water, you need to remove the excess before the system can reset:
Clean the small screens and the tiny flow plugs with warm, soapy water. Ensure the pin-sized holes are not blocked. A hard crust of salt forms over the
Unscrew the cap on the venturi housing (usually on the top of the valve).
Take a broom handle and gently push down on the salt. If the top layer is hard but there is hollow space or water underneath, you have a bridge. Break up the salt carefully to allow it to mix with the water again.