Cem Dual Mig 120 Manual [repack] -

If you are looking at the face of the machine without a manual, here is what the controls generally do: These are your voltage settings. Min + 1: Lowest power (thin sheet metal). Max + 2: Highest power (thicker steel up to 3-4mm).

Flip the tensioner arm, thread the wire through the guide liner, over the roller, and into the torch lead. cem dual mig 120 manual

If the machine gets too hot, the thermal cut-out will trip. The light will turn on, and the welder will stop until it cools down. 3. Setup and Wire Loading If you are looking at the face of

The Dual MIG 120 is designed primarily for light to medium-duty tasks. 230V (Standard UK/European plug). Amperage Range: Typically adjustable from 30A to 120A. Flip the tensioner arm, thread the wire through

Tighten the pressure roller just enough so the wire feeds smoothly. If you block the wire at the torch tip with your gloved hand, the rollers should slip slightly rather than bird-nesting at the drive motor.