The Electronic Control Module (ECM) may limit power to prevent damage. Potential Causes
Verify that the hydraulic fluid is at the proper level. Inspect the filters for debris. If contamination is found, drain and clean the tank, replace the filters, and blow out the lines. doosan fault code vpv00105 new
Use a multimeter to check the resistance of the P1 pump solenoid. If the resistance is outside the manufacturer's specified range (indicating an open or shorted coil), the solenoid must be replaced. The Electronic Control Module (ECM) may limit power
The pump may not respond correctly to operator commands. drain and clean the tank
A broken wire, loose connector, or corroded terminal between the ECM and the P1 pump solenoid.