Dp Dual Trac 20 Assembly Instructions Full __exclusive__ 〈Mobile TRENDING〉

Start at the lat bar attachment point. Thread the cable over the top pulleys, down through the "floating" pulley block, and back up to the anchor point on the frame.

Bolt the main vertical upright onto the base frame. Do not tighten these bolts fully yet; leaving them slightly loose helps with alignment in later steps. Step 2: The Seat and Backrest Carriage

Run the handles through a full range of motion without any weight plates pinned to ensure the cables are tracking correctly. dp dual trac 20 assembly instructions full

Secure the seat and backrest pads to their respective frames using the smaller hex bolts.

If your model includes the leg extension attachment, bolt the pivot arm to the front of the seat frame now. Step 3: Top Frame and Pulley Brackets Start at the lat bar attachment point

Lift the top horizontal frame piece onto the vertical upright. Secure it with the heavy-duty bolts and washers.

Attach the fixed pulley brackets to the top frame and the base. Note the orientation: the "open" side of the bracket should face where the cable will enter. Step 4: Cable Routing (The Critical Phase) Do not tighten these bolts fully yet; leaving

Insert the weight guide rods into the base. Slide your weight plates on one by one.

Use a silicone-based spray on the guide rods for smooth movement. Never use WD-40 , as it attracts dust and creates friction.