Are you installing this in a or low-pressure (gravity) system?
The Harvey HV3 uses block salt. Place two blocks of salt into the front compartment. Ensure the salt is sitting on the floor of the unit and is not "bridging" or stuck.
Because the Harvey HV3 uses a twin-tank system, it regenerates using water pressure. Proper drainage is vital. harvey hv3 water softener installation manual free
Connect a separate hose to the overflow barb on the side of the cabinet. This should be run through an outside wall so that any cabinet leaks are visible outside, preventing indoor flooding. Step 4: Commissioning the Unit
The softener must be protected from freezing temperatures and direct sunlight. Are you installing this in a or low-pressure
The HV3 features clear markings for water flow. Using high-quality flexible hoses is highly recommended to reduce vibration and make the unit easier to move for cleaning.
You will need three valves: an inlet valve, an outlet valve, and a bypass valve. Ensure the salt is sitting on the floor
Turn the inlet valve slowly to allow water into the tanks. Check for leaks immediately.
Connect the "In" port of the softener to the mains water supply after the bypass valve.