Enter programming mode by long-pressing the button until "00" appears.
The control housing must be installed so the door is visible during operation but protected from extreme temperatures. hormann a445 manual
2-digit 7-segment display for status and error codes. Enter programming mode by long-pressing the button until
Set the by navigating to menu "01" and holding the "Up" button until the desired position is reached, then press Enter. Set the by navigating to menu "01" and
Use separate cable paths for control wires and power lines to prevent signal interference. Ensure the mains cable enters the housing from the bottom . Initial Programming:
Integrated SKS (Closing Edge Safety Device) and photocell connections. Operating Temp: -20°C to +60°C . Installation and Commissioning
Set the by stopping approximately 5 cm before the floor and fine-tuning until "L" with a lower dash appears. A445 Error Codes & Troubleshooting