Jby6201 Manual -

Once the pump is primed and air-free, you are ready to apply coating.

Check for a clogged inlet strainer or a stuck intake ball valve. Tap the intake valve lightly with a wrench to loosen dried paint.

Submerge the suction tube into a bucket of water or mineral spirits. Place the smaller return tube in a waste bucket. Turn the power switch ON . jby6201 manual

Remove and clean the manifold filter (inside the machine) and the gun filter (inside the handle).

Increase pressure slightly until fluid flows steadily out of the return tube. This clears the pump. 3. Operation: Switching to Spray Mode Once the pump is primed and air-free, you

Ensure the high-pressure hose is tightly connected to the machine and the spray gun.

Failure to clean the JBY6201 immediately after use is the most common cause of pump failure. Submerge the suction tube into a bucket of

Always engage the trigger safety lock when not actively spraying.

Slowly turn the pressure knob clockwise. Test the spray pattern on a piece of cardboard. If you see "tails" (heavy lines on the top and bottom of the fan), increase the pressure until the pattern is even.