Kt 70 Installation Manual ★

: An optional remote "Ident" switch can be wired to the yoke for pilot convenience. 🛰️ Mode S Programming

: The unit should be located in the radio stack where it is easily accessible to the pilot.

: Connection to other high-power RF equipment (like DME) to prevent interference. Kt 70 Installation Manual

: Heavy-gauge wire is recommended to handle peak pulse loads.

The KT 70 is designed for standard panel mounting within the Silver Crown Plus product line. Specification 11.0 to 33.0 VDC (Compatible with 14V and 28V systems) Current Draw 35 Watts maximum Output Power 200 Watts peak pulse minimum Weight 3.90 lbs (1.77 kg) Dimensions 1.63" H x 6.25" W x 10.0" L Certification TSO C112 (Mode S) 🏗️ Mounting and Wiring : An optional remote "Ident" switch can be

: The manual describes how to set the specific aircraft address using a dedicated programming module or hard-wiring specific pins.

Following the manual’s checklist is critical for FAA Part 43 compliance. : Heavy-gauge wire is recommended to handle peak pulse loads

Unlike older Mode A/C transponders, the KT 70 requires a unique 24-bit ICAO aircraft address.

: The unit slides into a tray and is secured with a locking screw on the front bezel. Electrical Interconnect

: Must be connected to a compatible blind encoder (like the KEA 130A) or an encoding altimeter via a Parallel Gray Code (Gillham) interface.