The RGAM 12 is part of Lovato Electric’s legacy series of controllers. It is engineered to monitor a single-phase or three-phase mains supply and automatically start a generator if the mains voltage falls outside of preset limits. Once the generator is running and stable, the RGAM 12 manages the transfer of the load from the mains to the generator. Key Features:
The RGAM 12 interface is designed for simplicity. It usually features three primary modes:
Connect to the 12V battery. Ensure correct polarity (Terminal 1 is usually negative/ground). lovato 31 rgam 12 user manual
Setting the "Low Voltage" limit (e.g., 180V on a 230V system) that triggers a start. 6. Troubleshooting Common Issues
Monitors oil pressure, engine temperature, and fuel levels. The RGAM 12 is part of Lovato Electric’s
While the physical booklet is often tucked away in a control panel, this guide serves as a comprehensive overview of the technical specifications, wiring logic, and programming steps required to get your RGAM 12 up and running. 1. Device Overview
The back of the RGAM 12 features a series of screw terminals. Accurate wiring is critical to prevent damaging the controller or the generator’s alternator. Basic Terminal Mapping: Key Features: The RGAM 12 interface is designed
To access the internal settings (thresholds, timers, and delays), you must enter the programming mode. Common Adjustable Parameters:
If the mains are healthy but the generator keeps running, check the sensing fuses or the voltage calibration in the settings.
Always consult a qualified electrician or generator technician before modifying high-voltage control panels.