Makerbase Mks Dlc V21 Manual Link ((full)) File

Once connected via USB (usually at ), you may need to adjust these settings in the console: $100, $101, $102 : Steps per mm for X, Y, and Z. $32=1 : Enable Laser Mode (if using a laser).

Use the Spindle relay or PWM output to control your motor tool. 💻 Software Configuration makerbase mks dlc v21 manual link

Ensure the "Enable" pin on the driver matches the "EN" pin on the board. Once connected via USB (usually at ), you

Before powering on your board, ensure all connections are secure to avoid shorting the components. 1. Power Connection makerbase mks dlc v21 manual link

Place jumpers under the drivers to set your microstepping (usually all three jumpers are installed for 1/16 or 1/32 stepping). 3. Motor Wiring