If you cannot access the software menu, you may need to perform a physical reset on the motherboard.
Remove the screwdriver/jumper and allow the system to boot. It should return to the factory "New Device" setup wizard. Method 3: Battery Removal (RTC Reset) napco dvr password reset new
Remove the screws on the side and back of the DVR. If you cannot access the software menu, you
Put the battery back in and power on. This may reset the system clock to 2000-01-01, which sometimes triggers a default password state. Important Considerations After Resetting Method 3: Battery Removal (RTC Reset) Remove the
Before attempting a hard reset, try these common default credentials. Many installers leave these as-is: admin Default Password: 1234, 123456, or simply leave it blank. Alternative Admin: 888888 or 666666. Method 1: The "Security Code" Recovery (Software Based)
Use a flathead screwdriver or a jumper cap to connect these two pins.