Narco Escort Ii Installation Manual !exclusive! Full ⇒

Note: Always verify your specific unit's Mod level against the wiring diagram on the chassis sticker, as Narco made slight variations during production. 4. Antenna Connections

Typically reserved for external VOR/LOC needle outputs if connecting to an external CDI.

If you are looking to install or reinstall this classic unit, following the original technical specifications is critical for both safety and legal compliance. 1. Pre-Installation Requirements narco escort ii installation manual full

The Escort II requires two distinct antenna inputs via BNC connectors:

A standard 50-ohm VHF whip antenna. Ensure the VSWR is less than 3:1 for optimal transmission. Note: Always verify your specific unit's Mod level

Avionics installation should be performed or supervised by a certified A&P mechanic or an FAA-approved radio shop. Improper wiring can lead to electrical fires or loss of critical navigation equipment.

A "V" or "T" style dipole antenna. If you are sharing this antenna with another NAV radio, you must use a signal splitter (diplexer) to avoid signal loss. 5. Post-Installation Testing Once wired, perform the following checks: If you are looking to install or reinstall

Allow at least 11 inches of depth behind the panel to accommodate the unit, the rear connector, and the cable service loop.

While the Escort II is relatively efficient, ensure there is adequate airflow behind the stack to prevent heat soak, which can drift frequency stability. 2. Physical Mounting The Escort II uses a standard lateral mounting tray.