Sinotimer Mc101 | Manual

For models, connect Terminal 5 (positive) and Terminal 4 (negative) to the control input of your Solid State Relay. Configuration and Setup

For optimal control, you can trigger the function. Access the internal menu and locate the "AT" parameter. sinotimer mc101 manual

Hold the (or SET + <) keys for 3 seconds to enter the menu. Use the arrows to find the "Unit" parameter. Change the value from 000 (Celsius) to 001 (Fahrenheit). Hold the MODE key for 3 seconds to exit and save. Entering PID Auto-Tuning: For models, connect Terminal 5 (positive) and Terminal

Set "AT" to 1. The AT light on the panel will blink until the cycle is complete and the controller has calculated its PID constants. sinotimer mc101 manual