No items in cart

Subtotal

$ 0,00

Change the oil after the first 100 hours of use for a "new-to-you" vintage machine, then every 1,000 hours or annually.

The Strands S68 is a heavy-duty, gear-driven pillar drill known for its rigidity and high torque. While variations exist based on the year of manufacture, the core specs usually include: 25mm to 30mm (in steel). Spindle Taper: Morse Taper 3 (MT3). Spindle Travel: 130mm to 150mm.

Apply a light coat of lithium-based grease to the rack teeth and the external surface of the quill to ensure smooth vertical movement.

8-speed or 12-speed gearbox (ranging from ~100 to 2900 RPM). Motor: Typically a 2-speed 0.9/1.2 kW motor. Column Diameter: 100mm. Table Size: 400mm x 400mm or 500mm x 350mm. Installation and Setup Power Connection

The S68 usually runs on 3-phase power. Ensure the motor rotation matches the direction indicator on the headstock. If the drill is spinning backward, swap any two of the three phase wires.

What is the and year of manufacture from the nameplate? g., 220V vs. 440V)?

Use a standard drift key to remove MT3 tools. Never strike the spindle directly with a hammer.

Check the oil level monthly. The oil should sit halfway up the sight glass located on the side of the headstock. Greasing Points

Strands — S68 Manual Pdf

Change the oil after the first 100 hours of use for a "new-to-you" vintage machine, then every 1,000 hours or annually.

The Strands S68 is a heavy-duty, gear-driven pillar drill known for its rigidity and high torque. While variations exist based on the year of manufacture, the core specs usually include: 25mm to 30mm (in steel). Spindle Taper: Morse Taper 3 (MT3). Spindle Travel: 130mm to 150mm.

Apply a light coat of lithium-based grease to the rack teeth and the external surface of the quill to ensure smooth vertical movement. Strands S68 Manual Pdf

8-speed or 12-speed gearbox (ranging from ~100 to 2900 RPM). Motor: Typically a 2-speed 0.9/1.2 kW motor. Column Diameter: 100mm. Table Size: 400mm x 400mm or 500mm x 350mm. Installation and Setup Power Connection

The S68 usually runs on 3-phase power. Ensure the motor rotation matches the direction indicator on the headstock. If the drill is spinning backward, swap any two of the three phase wires. Change the oil after the first 100 hours

What is the and year of manufacture from the nameplate? g., 220V vs. 440V)?

Use a standard drift key to remove MT3 tools. Never strike the spindle directly with a hammer. Spindle Taper: Morse Taper 3 (MT3)

Check the oil level monthly. The oil should sit halfway up the sight glass located on the side of the headstock. Greasing Points