Xh-m608 Manual ((exclusive)) Here

The relay on the board should be placed "in-line" with one of the wires (typically the positive) of your charger or load.

Relay closes when voltage ≥ P2 (upper limit) and opens when voltage ≤ P1 (lower limit). Setting the Limits (P1 & P2)

The XH-M608 acts as an intelligent switch. It does not provide power itself; it controls the connection between a power source (charger) or a load and your battery. Xh-m608 Manual

Relay output (works as a switch for your charger or load). Dimensions: Approximately 66 x 46 x 16mm.

Set a value from (minutes) to enable a timed charge or discharge session. 4. Advanced Functions & Troubleshooting ainow.inhttps://ainow.in XH M608 Battery Charge And Discharge Module - AINOW The relay on the board should be placed

Relay stays closed only when the voltage is between the lower (P1) and upper (P2) limits.

The module uses a menu system (P0 to P3) to define its behavior. Use the button to navigate and the + / – buttons to adjust values. P0: Operating Mode Selection It does not provide power itself; it controls

The relay stays closed to power your load until the battery hits the undervoltage limit. 3. Programming & Modes